如何有效地安裝好金屬軟管-江門艾瑞精密機械技術分享

來源：本站 時間：2019-03-16 11:53:22 瀏覽次數： 592

在實際安裝過程中，考慮到用尺子按計算結果去量軟管長度再進行安裝可能會影響生產效率，國外有些生產商把尺子直接裝在軟管上，安裝完后把尺子剪掉。金屬軟管可以水平安裝，也可以垂直安裝或斜向安裝，最理想的狀態是垂直安裝，同時應避免安裝在車輪附近，必要時可以加裝擋板。

　　In the actual installation process, considering that it may affect the production efficiency to use a ruler to measure the length of the hose according to the calculation result before installation, some foreign manufacturers install rulers directly on the hose and cut off the ruler after installation. The metal hose can be installed horizontally, vertically or diagonally, ideally vertically, and should not be installed near the wheels. Baffles can be added if necessary.

　　一般可把金屬軟管分為3種長度：第1種是壓縮長度，即把軟管壓縮到極限位置時的長度；第2種是安裝長度，這是處于最大位移量的一半的中間位置時軟管的長度；第3種是拉伸長度，軟管被拉伸到最大極限時的長度。金屬軟管安裝時應將軟管處于中間位置，即所謂安裝長度。在此位置安裝狀態下，軟管受到軸向載荷時可以有2個移動方向，否則若只能向1個方向移動，將會影響金屬軟管的強度，降低使用壽命。

　　Generally, the metal hose can be divided into three lengths: the first is the compression length, that is, the length of the hose compressed to the limit position; The second is the installation length, which is the length of the hose in the middle of half of the maximum displacement. The third is the stretch length, the length when the hose is stretched to its maximum limit. Metal hose installation should be in the middle of the hose, that is, the so-called installation length. Under the installation condition at this position, the hose can move in two directions when it is subjected to axial load, otherwise, it can only move in one direction, which will affect the strength of the metal hose and reduce its service life.

文章出自江門艾瑞 轉載請標明出處

VCR接頭訂購聯系：秦先生 17688183787